Air-Flow Application for best results
Attach the film to the
pallet by either tying or sliding film under the lower layers
of the product.
Ensure the inner layer
of film is towards the pallet being wrapped (to maximize
Ensure clear access around
the pallet and then commence wrapping.
Stretch the film prior
to turning each corner ensuring the film is securing the
load to the pallet.
Minimal overlap required
is, +/- 1 inch as AIR-FLOW relies on tension and not tack.
When finishing off the
wrap, always bunch then cut the film and tie into the edge
of a previous layer or pull the cut end under a corner of
The normal wrap configuration
would be two layers wrapped onto the bottom of the pallet,
spiralled up the load and two layers at the top. On occasion
a second layer down the pallet may be required for heavier
or unstable loads.
Critical Step: Bunch film
prior to cutting & tying off to ensure easy start up
for next load. SEE PICTURES BELOW FOR CORRECT CUTTING..
Learn more about Air-Flow